Search results

I have setup my transmitter with the Blade mCPx and have checked and verified that the switch is working to get it into idle up mode. However, I cannot get it to work right with phoenix. When I flip the switch and slam the throttle down, it kills the throttle. What am I doing wrong?

Got my new roller in today and it works great!

I've been tinkering with these things for a little while. I started off heavy into them but slacked off for a little while. But now I'm trying to get my head back into it and learn the programming language needed to write 'sketches'. The arduino IDE uses C/C++. There is so much you can do with...

I'd like a BSOD with a large coke and large fries. Even Sonic has puter problems.

Can anyone tell me how to correctly setup the software with this transmitter? I am trying to get it to work better but the helis are either way too sensitive or they won't fly at all. I have tried different expo settings and other things but can't find the sweet spot.

Yo Yo! Wassup!!!??? Mail carrier brought this today!

I have this motor from a plane and want to replace the electronics with DSMX compatible stuff. The motor is a hobby zone part and the number is HBZ6532. I don't know any more details for it. It came in an Aerobird Xtreme. It swings a prop part no. HBZ6507.

I recently crashed my 270 CFX and it was a pretty bad crash. I busted two servos and bent the bolt that holds the head on. I'll be replacing a few parts and of those is a linkage from the swash to the blade grip. I have one but the other is missing. I'll be using the one I have to measure and...

*edit*...nevermind. I did a little more research and found them. They are here: Gear Set: H3050 | HorizonHobby I need to rebuild my SPMSH3050 servos. I had a crash which stripped two of them. Where can I get replacement gears? Thanks anyway...

Wouldn't you know it. These trees hate helicopters. This oak reached out and grabbed my heli and caused damage to the canopy mounts. I had to fly the last battery with it naked...Embarrassing. I hope I won't have to get a new frame just to get the little ball end pins. The two on the front of...

I got 3 1S 500mAh LiPos. Charging them in parallel would be 3A at 2C rate right? You add all capacities then double that to get 2C correct?

This thread is for discussion related to my thread in the Flight Log Discussion Forum. You can view it here. I'll be including the flight date with my posts so include that for reference or you can link directly to the post. To do that right click on the post number (permalink) located by the...

Need to upgrade the wire size. Having a hard time getting the pins out.

Got this acepower No. 2904 NiCd pack and was wondering what a good charge current is. I'll be using my UP100AC charger in auto mode.

Neighbor kid brought this to me but can't get it to run. It's old with an am xtal. Any ideas what to check?

This port on my charger can connect to my computer but I can't figure out what its for. Firmware update possibly?

So phones made in Vietnam cost $850 to make?

What say we have a forum to record flight logs for both heli and plane? Maybe it's been done before and deemed not useful?

I'm going to start posting into this thread, information pertaining to flights of my 270 CFX. I don't want a bunch of threads floating around about one topic. If there is anything you would like to discuss with me about any of my entries, please refer to the thread in the General Hellicopter...

Got out again and flew for almost 4 minutes. The wind was much higher that I am used to and was hot. The small helicopter was being blown around more than I have experienced in the past. Due to this, I was challenged with keeping it in an area I had designated. This almost proved to be...