danhampson
Member
After alot of research over the last week, ive made a decision and pulled the trigger on a 550 pro dfc after reading horror stories about tail gear failure on the 600 pro dfc, The company who ive bought it from remove unwanted parts and reduce the cost of the kit. The parts that ive had removed are 3GX and rudder servo.
the specs of the kit are as follows.
trex 550 pro dfc kit
550mm 3g carbon main blades
90mm carbon tail blades
730mx 850kv brushless motor
ds615 x3 (cyclic servos)
cc talon 90
in addition to the standard parts
savox sh1290mg (rudder servo)
MSH brain
2 spektrum sats
hv bluetooth module
hobbywing phase sensor
castle bec pro (im going to install this as ive also read about bec failures on the cc talon 90)
The kit should be with me tomorrow at some point and the build will start tomorrow evening as ive got this week off work.
the specs of the kit are as follows.
trex 550 pro dfc kit
550mm 3g carbon main blades
90mm carbon tail blades
730mx 850kv brushless motor
ds615 x3 (cyclic servos)
cc talon 90
in addition to the standard parts
savox sh1290mg (rudder servo)
MSH brain
2 spektrum sats
hv bluetooth module
hobbywing phase sensor
castle bec pro (im going to install this as ive also read about bec failures on the cc talon 90)
The kit should be with me tomorrow at some point and the build will start tomorrow evening as ive got this week off work.