450 Tail grip washers

[trainrider06]

I have taken a piece of plastic before and manufactured a tab on a servo before....JB weld works wonders!

 

[bignatertater78]

that notion had crossed my mind..but thought jb was fer metal parts only?..ill have ta pick up some n try it then..thanks for the heads up rider!

- - - Updated - - -

in the bottom of the box where our info is..what does rep power mean? jus curious

 

[trainrider06]

Cut you a little piece of plastic, just wide enough as servo itself...
Length don't matter, but try to keep it about 1 inch long...
Lay it over the edge of a table with half of it hanging off....gently put some heat to it...
Bend it to 90 degrees, now lay it onto the side of the servo with just a drop of JB weld on the
bottom, pushing it butt up against the broken tab.
Now lay a thin coat of JB weld over it/covering the edges of the
Piece all the way up to an around that and the broken tab
Let dry a day, then drill your holes for servo screws....
I can post a pic of the servo I did if that'll help
explain it better...

 

[bignatertater78]

how do i butt it up to the broke tab when its not broke flush ?..its a jagged like break

 

[trainrider06]

What you'd need to do is use a little peice of plastic on the other side you can't use too thick a plastic or else your "new tab would be too thick...the plastic pieces are going to be your new tab

 

[bignatertater78]

if ya dont mind a pic wood prolly help me out ..jus whenvr u get time..please.