Tony
Staff member
Make sure the throttle stick is "low=off" and "High=full power". After that is done, if the motor is rotating backwards, just reverse any two wires on the motor. then, check your collective. do all servos go up and down with the stick? If not, find the 1 that is not the same as the others. Yes, only one servo even if it's moving in teh correct direction. after you reverse that servo, do into your swash mix and take the +60 to -60 and that will reverse your collective. Now, check your cyclic. Right should be right, forward should be forward, and so on. If for example forward is backward on teh swash, go back into your swash mix, and do the same for the elevator. It takes a bit, but you will get it.
Oh, and I do have a few videos on this process. They may be worth another watch.
Oh, and I do have a few videos on this process. They may be worth another watch.