Yeah, did all that when i first got it, i flew it a couple of times, then the crash into the trees, knew it was coming, shut down motor, it went through the trees pretty quick, im assuming it hit pretty hard, it trashed a set of blades, and stripped gears on all cyclic servos, i replaced all servos, installed a new set of blades, and flew it again, this time, i had a somewhat rough landing, didn't break anything, but now i have this, yesterday i took a few minutes with it, with motor not connected to main gear, it will move slightly, in normal, idle up 1, they start really moving, switch to idle up 2, they move at least 30° or more, very irratic, never the same, so i dont know what it will do, i know i have heard people talking about th 360 laying over during spool up, this one would do it, if i don't cut throttle.
One qyestion, when i go into forward programming, to adjust subtrim, should the servos jump, and move up, or down depending on the mode, once you back out out of subtrim, they go back to where they were? They move alot, i mave have the swahplate adjusted too high, or too low.
Dont know.