Peter Neal
New Member
G'Day All
I am having some trouble setting up my new Assan GA250 gyro with an Align DS420 digital tail servo on my E-Razor 450.
The problem is that I can only get the gyro to lock into Heading Hold mode (solid blue light) after I enter some slight rudder trim or sub-trim on the DX6i.
I cannot seem to be able to set up the gyro with all sub trims and trims set to zero.
My first couple of flights have noticeable tail drift which I think might be linked to the slight trim/ sub trim I have entered to get the gyro to lock into HH mode???
I have also tried lowering and increasing the gyro gain for HH mode but seem end up with this set at about 55%. Any higher and tail wag starts becoming an issue.
The tail servo and horn appear to be 90 degrees to the naked eye but maybe this is the issue?
Any suggestions to resolve this?
Cheers
Pete
I am having some trouble setting up my new Assan GA250 gyro with an Align DS420 digital tail servo on my E-Razor 450.
The problem is that I can only get the gyro to lock into Heading Hold mode (solid blue light) after I enter some slight rudder trim or sub-trim on the DX6i.
I cannot seem to be able to set up the gyro with all sub trims and trims set to zero.
My first couple of flights have noticeable tail drift which I think might be linked to the slight trim/ sub trim I have entered to get the gyro to lock into HH mode???
I have also tried lowering and increasing the gyro gain for HH mode but seem end up with this set at about 55%. Any higher and tail wag starts becoming an issue.
The tail servo and horn appear to be 90 degrees to the naked eye but maybe this is the issue?
Any suggestions to resolve this?
Cheers
Pete