Search results

do you build or just buy and fly? nice fleet.

Nice looking plane I have an 1150mm that I don't have the stones to fly yet, its my second plane I bought and after getting it ready to fly didn't want to see parts all over the place since I am a novice at this only been flying for over a year.

Nice

yes, it makes a lot of sense. I have done this a few times but my table is most likely not real level since it is a card table that was in storage and got wet and bowed in the middle. will have to make sure its level next time thanks. its not the table that I do my building on just the table...

OK, thanks not sure if my ESC's are BlHeli but can check it out. Tried to fly a little yesterday and flies nice but keeps drifting to the right not sure what is causing that tried to adjust on the transmitter but didn't work so am thinking PID is where I have to do the tuning.

I just built my first Quad and am trying to figure out how to get the drift out of it. When I try to hover in one spot my quad likes to drift to the right, have tried to fine tune on the transmitter but it doesn't seem to have any effect. Am kind of thinking I may have to play with the PID but...

I would like to thank you for the advise to calibrate the ESC's. I did what you suggested and it worked really well and after a little reading and Utube I figured out what I was doing wrong. Now my quad is ready to fly its maiden voyage and first repair. I am using 3" blades and am going to...

I was not aware that I could have the controller board plugged into the computer for beta flight and then plug the batterie in. I thought that may cause a conflict with the controller board and the computer

Thank you for the input but found that I am supposed to use UART1 since I am using J6 for my receiver but still not sure about the OPTO ESC and how to spin up the motors. first time using OPTO and not sure which way to go.

not sure why but when I try to flash the boot loader is not recognized and am using the Omnibus F4 V3 controller not the V2 which I understand is a completely different controller and still not clear which to flash with although the package says F4SD 3.2.0 which I am assuming is the SD model.

update: The problem I was having with my receiver was that I was trying to use UART 3 or 6 and since I am using DSM2 J6 for the receiver I have to be on UART1. Still can't get the motors to spin up so am thinking that I have to supply a voltage to the signal line since I am using OPTO style...

I think that I have done about everything that I am supposed to and still I have no recognition of my receiver. Am I supposed to hook up another 3 or 5V supply somewhere on the controller board that I am not aware of? Other than the one from the batterie to the LIPO input? I seem to be...

I am building a quad and having trouble with beta flight recognizing my receiver and motors. I have a spektrum serial receiver w/autobind that has bound to my transmitter which is a DX6e. I have an Omnibus F4 V3 controller card with 30A opto ESC's. I am stuck there because I have read that I am...

Question, I am trying to set up a quad using a Spectrum serial receiver and an Omnibus F4 V3 controller board. Is it the same as setting up the DX9 in Beta flight? Am new at this so its all confusing to me. Not sure where to start am getting no response from my receiver or motors and am using...