auctioneer
New Member
Ok here is the deal. got a used exi 450 and been trying to set it up now for weeks with dx6i/ar6100e and 30amp Exceed RC Proton. I have been able for weeks now to bind radio to rx. today went and changed the 4 batterys in tx and took heli outside to see if I got anywhere's with setup. well I turn tx on pluged battery to esc and when to give a little throttle and all the servos were going all different directions. so I packed it up and brough it inside, disconnected motor and same thing all servos jump around when giving any input on any of the channels. so I pulled esc and rx when into tx and setup a tx for airplane model,bind rx, hooked up esc and one servo(rudd) it moves fine, hooked another servo in to (elev) and when I move left stick left/right the elev jiggers around too. I have no rx 4 cell battery holder to plug into rx to see if the servos jigger then.
is there away to make something up to power rx without esc.
I'm to the point to just throw all this stuff the hel_ out because I can't get to heli setup at all.
I have not had any problems with this tx,rx or esc since I brought it and been trying to set the head up for weeks now. it just happen after I put new aa batterys in tx.
thanks
allen
is there away to make something up to power rx without esc.
I'm to the point to just throw all this stuff the hel_ out because I can't get to heli setup at all.
I have not had any problems with this tx,rx or esc since I brought it and been trying to set the head up for weeks now. it just happen after I put new aa batterys in tx.
thanks
allen