trainrider06
Active Member
I know this is an old bird, but I dearly love my SR's....I have two of them, one is motor driven, flies just fine, have it dialed in nicely...
The other I put a belt kit on it. At first it flew great, until I came in nose in one day had a little right side tilt, caught the blades and
promptly busted my tail servo, bent tail boom, and of course a blade grip.....anyway, after getting it back together, now it blows out
the tail upon any throttle increase, the severity of it depends on how rapid it blows out (tail blows out to the right, looking at the back
of the heli) I use a DX6i tx on both helis. gyro gain sittings are around 60-65 HH and around 30 on rate. I cannot raise settings much higher
because I'll get tail jitters. Also this is in normal mode....I've tried idle up and had to switch back quickly and wrestle the heli back into shape
when I did. I started messing with sub trim a bit and that seemed to help some...
I'm lost as to where to proceed. Also servo pitch slider about as dead on as they can be....
Rodney
The other I put a belt kit on it. At first it flew great, until I came in nose in one day had a little right side tilt, caught the blades and
promptly busted my tail servo, bent tail boom, and of course a blade grip.....anyway, after getting it back together, now it blows out
the tail upon any throttle increase, the severity of it depends on how rapid it blows out (tail blows out to the right, looking at the back
of the heli) I use a DX6i tx on both helis. gyro gain sittings are around 60-65 HH and around 30 on rate. I cannot raise settings much higher
because I'll get tail jitters. Also this is in normal mode....I've tried idle up and had to switch back quickly and wrestle the heli back into shape
when I did. I started messing with sub trim a bit and that seemed to help some...
I'm lost as to where to proceed. Also servo pitch slider about as dead on as they can be....
Rodney