Trucks I Finally Got My T-maxx Pro 15 Running Again

Having a slight issue get in the throttle linkage correct so it pulls the carburetor open and close right
 
Last edited:

Tony

Staff member
Hey Brandon, sorry for the late post.

The throttle linkage is on backwards. The carb arm should be on the muffler side. You will need to put the brake lever the other way and swap over the linkages.

As for the wheels spinning with no throttle, it sounds like the throttle is too high or the low end needle is too lean, or both.
 
Hey Brandon, sorry for the late post.


The throttle linkage is correct on the bottom side the issue I was having was not sitting it correctly. and finally still working on the idle speed one driving around it casually suddenly dies driving almost full throttle it just suddenly stalls And I think the slipper clutch is giving me issues


As for the wheels spinning with no throttle, it sounds like the throttle is too high or the low end needle is too lean, or both.
The throttle linkage is on the right spot the issue I was having his not getting it set right. and getting it to idle was a very high idle and when I was driving it today it du Soleil dies after takeoff and almost full throttle
 
The high speed needle say if it was closed all the way and you do one revolution is that considered a full turn our half of the turn
 

D.O.G.

Goblin 380 Supporter
Hey there Brandon. When I had my Savage 4.6, a full turn is a full turn. My savage was 1 1/4 turn. Try one full turn and see what happens.
 
It seems like the engine is flooding itself out when I try to start it with a glow igniter on top the engine wants to lock up even when I have a even when I haven't Prime the engine so is it flooding itself or is it the battery for the easy start cuz it is old
 

Tony

Staff member
Reset all needles to factory settings described in the manual and start the tuning over again. You have to constantly tune a nitro engine, there is no one setting that is perfect for all occasions.
 

RandyDSok

Well-Known Member
I'm going a little further than what Tony said... The number of turns listed in the manual is the STARTING place from where you start tuning the engine. Each one is slightly different and will have different settings but you need a place to start from. So it's sort of an art when it comes to dialing in a air/fuel mixture. In addition, each day has slightly different pressure, temperature and moisture... so the setting you had yesterday that may have been perfect, will be slightly different today or tomorrow.
 
I'm going a little further than what Tony said... The number of turns listed in the manual is the STARTING place from where you start tuning the engine. Each one is slightly different and will have different settings but you need a place to start from. So it's sort of an art when it comes to dialing in a air/fuel mixture. In addition, each day has slightly different pressure, temperature and moisture... so the setting you had yesterday that may have been perfect, will be slightly different today or tomorrow.
ty
 

Tony

Staff member
Cannot see if the needle is flush or not. When looking at the low speed needle, you need to look at it from the side. In the picture, you are looking at it straight on and with a 2d photograph, we have no sense of depth (as we would with out eyes). But, going off of the light, it looks like it is a little too rich. Remember, this needle is only used when the truck is idling.
 
Top Bottom