Quad Conspiracy 220

[Ben]

so i have a blade conspiracy 220 still kida new to the hobby. Recently wrecked it , not that bad in my opinion changed one ESC used beta flight to calibrate it etc , now it’s flying funny , it doesnt have much punch out and doesnt want to stay level , throttle seems somewhat un controllable only after few seconds of flight , im pulling my hair out on this one please help lol

 

[Tony]

Did you go back with the same brand and size on the ESC?

 

[Ben]

Did you go back with the same brand and size on the ESC?

Yes exact same ones

 

[Tony]

Interesting. And you are 100% sure that all ESC's are calibrated together? Have you gone into betaflight and watched where the bars are moving to? After you raise the throttle (props off) some of the motors will speed up and the others will spool down because of the gyros.

 

[Ben]

Interesting. And you are 100% sure that all ESC's are calibrated together? Have you gone into betaflight and watched where the bars are moving to? After you raise the throttle (props off) some of the motors will speed up and the others will spool down because of the gyros.

When i hook it ip to beta flight and calibrate the motors they dont stop beeping , they beep for atleast 3 min and dont sound in sink when they beep .

 

[Tony]

I have had times when the flight controller is hooked up to the computer, it will not work correctly. But once I disconnect it, it will start working great and like it should.

 

[Ben]

Not 100 % sure abought the esc’s being in sink , fairly new to beta flight so im prolly not using it to its full potential lol

 

[Tony]

Welcome to my world. lol. If I had it here with me, I think I could narrow it down faster. Sure sounds like something is not communicating in one way or another.

 

[Ben]

Ok thanks for your help , ill attempt to re cal the esc’s , hope its not the fcb

 

[Ben]

Update replaced 2 esc’s and a motor , seems it runs slightly better , however when i hover it seems like it has a slight miss , jitter , like a motor missing ?

 

[Tony]

Sorry for the delay, been on the road this week.

Is there any way you can get me a video of what it is doing? That would help out a lot in determining what it is or is not doing.