Hi,
I have a YEP esc and I would like to program it with programming card such that when Aileron channel is pushed to the right -> motor rotates in one direction
pushed to the left -> motor rotates in reversed direction
stay in the middle -> stop
There is a Rev.(Nevy) on the programming card, but just cannot program it. The middle and right work fine with stop and full speed, but when I push the stick to the left and hit enter at Rev. (Nevy), it just doesn't allow me to make that change. This esc has no manual and I have been searching over the internet for tutorials, no luck yet. Does anyone have a luck to get it to work properly?
Thank you!!!
I have a YEP esc and I would like to program it with programming card such that when Aileron channel is pushed to the right -> motor rotates in one direction
pushed to the left -> motor rotates in reversed direction
stay in the middle -> stop
There is a Rev.(Nevy) on the programming card, but just cannot program it. The middle and right work fine with stop and full speed, but when I push the stick to the left and hit enter at Rev. (Nevy), it just doesn't allow me to make that change. This esc has no manual and I have been searching over the internet for tutorials, no luck yet. Does anyone have a luck to get it to work properly?
Thank you!!!