The ball link on the servo arm ,now managed to get a nut on back,trashed blades landing gear and bent the pin that runs throgh centre gear in swash servo ,the last crash (which was worse) bent the same pin in the other 2 swash servos (again the gears were ok) had to order rebuild kits from your country and incurred import tax which I didn't count on,measured these pins at 1.59 mm been struggling to find any rod to suit hence ordering those kits ,ones from everywhere else just have gears in them but ordered some ss 1.5 mm to try,is this a common problem?,by the way got pheonix 5.5 but gonna but too late for me to get on tonight,
Regards,
Rick.