Graham Lawrie
Well-Known Member
Right guys, I changed the main shaft bearings on my 550 and spooled up. Just as it is about to lift off just above half throttle, the tail starts to wag violently
I have done the following and it has not made a bit of difference:
1. Removed tail rotor completely and checked all bearings and movement: smooth as smooth.
2. removed torque tube checked for alignment/bend and bearing.
3. Changed main shaft bearings.
4. Gyro settings on DX6i up and down as high at 85 and as low as 58 no difference at either end of the scale.
I am contemplating doing the whole 3gx set up??
As always any suggestions welcome
I have done the following and it has not made a bit of difference:
1. Removed tail rotor completely and checked all bearings and movement: smooth as smooth.
2. removed torque tube checked for alignment/bend and bearing.
3. Changed main shaft bearings.
4. Gyro settings on DX6i up and down as high at 85 and as low as 58 no difference at either end of the scale.
I am contemplating doing the whole 3gx set up??
As always any suggestions welcome