Just got some new Dal6045 and 5045 props. Much stiffer than the cheapies I had.
The 6045 are very tight going on the motors. to the point I would really need to force them on. Do not want to damage the motor.
Any suggestions on opening that hole up. Drill it bigger? Or try to Sandpaper it a little?
Hate to screw them up. I did buy 5 full sets and all the 6045 are tight. The 5045 are just fine...
Your thoughts?
The 6045 are very tight going on the motors. to the point I would really need to force them on. Do not want to damage the motor.
Any suggestions on opening that hole up. Drill it bigger? Or try to Sandpaper it a little?
Hate to screw them up. I did buy 5 full sets and all the 6045 are tight. The 5045 are just fine...
Your thoughts?