General Tail Servo.

[concodd]

Hi people, well the replacement servo arrived and was installed, and still I have nothing. Totally frustrating, have purchased a brand new 3GX and Tail servo (not cheap) and am still getting nothing. I just don't understand that when I plug a servo tester into the rudder port and attach the tail servo to that, the thing works great. I know the signal from the Rudder stick on the TX is getting to the 3GX because when I am doing the rudder settings the lights on 3GX are responding. I am at wits end with this, and I bet it is something so minor. Does anyone have any ideas, I will take any at the moment.

 

[fran11784]

Only thing I could think of is the pulse width set right? But you probably checked that already

 

[concodd]

Yes, made sure I checked that because I had to change it to 720 so I did not burn it out.

 

[Slobberdog]

Look in the end of the 3gx and make sure your pins are all ok.

 

[concodd]

Just checked the pins, they look fine. Just cannot understand why, when I plug the servo tester into that port, it powers up the tester and if I plug the servo into the tester it works fine.