Erfan
Member
Hi guys!
I have a Trex 450 Plus DFC with the 3GX MR unit.
I have some issues when trying to setup a level swash.
I'm able to do it at midstick, that is at 50 but I cannot seem to get it right and level at 0 and 100, that is low and highstick.
I have watched several videos, they all say the same thing, you level the midstick position, get your server arms correct and then you look at low and highstick and make sure they are OK by adjusting the endpoints.
Doing this does not work since the manual (Trex 450 Plus DFC) says that aileron and elevator endpoints should not be changed in the TX and I cannot do it at the 3GX MR unit. But I have also seen people setting correct endpoints by changing the swash AFR.
From what I have understood the 3GX MR unit does the mixing for it self, so in the TX you choose swash type = 90 degrees even thou it is a 120 degree ccpm and the unit does the mix by it self.
SO when this is done I wont get the swash AFR menu so that I can set the end points for the bad servos so they all become level. If I try to do this with regular end point adjustments it will not help since its already mixed and changing a channel affects 2 or 3 servos together.
So I'm completely lost here, I have read so many articles and watched so many videos but the all are about a "real" 120 ccpm were the TX does the mixing, is there anybody out there with the same heli as I have and the 3GX MR unit which knows how to do the level at low and high stick?
Also this is the RTF version which came with Align T6 transmitter which is a Futaba 6J transmitter, for those of you perhaps having the same.
Thx in advance!
I have a Trex 450 Plus DFC with the 3GX MR unit.
I have some issues when trying to setup a level swash.
I'm able to do it at midstick, that is at 50 but I cannot seem to get it right and level at 0 and 100, that is low and highstick.
I have watched several videos, they all say the same thing, you level the midstick position, get your server arms correct and then you look at low and highstick and make sure they are OK by adjusting the endpoints.
Doing this does not work since the manual (Trex 450 Plus DFC) says that aileron and elevator endpoints should not be changed in the TX and I cannot do it at the 3GX MR unit. But I have also seen people setting correct endpoints by changing the swash AFR.
From what I have understood the 3GX MR unit does the mixing for it self, so in the TX you choose swash type = 90 degrees even thou it is a 120 degree ccpm and the unit does the mix by it self.
SO when this is done I wont get the swash AFR menu so that I can set the end points for the bad servos so they all become level. If I try to do this with regular end point adjustments it will not help since its already mixed and changing a channel affects 2 or 3 servos together.
So I'm completely lost here, I have read so many articles and watched so many videos but the all are about a "real" 120 ccpm were the TX does the mixing, is there anybody out there with the same heli as I have and the 3GX MR unit which knows how to do the level at low and high stick?
Also this is the RTF version which came with Align T6 transmitter which is a Futaba 6J transmitter, for those of you perhaps having the same.
Thx in advance!