Hello again guys I have a bit of an issue with my blade 400. I was using it on my training wheels to practice some nose in hover when I got kind of bored with that and wanted to fly a little. The flying went ok till I was about to quit and was just kind of taxiing back to asphalt to land and all of a sudden the helicopter just dumped to one side and fell out of the sky. The esc wouldn't fire back up. So I got it home and noticed the tail servo was not moving when I did get the esc to come back on. After powering back off and disconnecting the servo I noticed the servo was very hard to move by hand so I plugged in one of my old eflight dflrds76 servos that came off either the blade 400 or 450 I can't remember and it seemed to work ok. But anyway the problem I'm having is the helicopter want's to spin out of control no matter what adjustments I make. The servo that got tight was a hitec hs65hb and the gyro is a futaba gy401. I had to put a shorter horn on the hitec to get it to fit in the stock location but it worked great untill it's demise. I know that the hitec was an analog servo and the eflight is digital so i moved the switch on the gyro to digital but it didn't help. Anyone have any ideas?