1. If you would like to get rid of these banners and the ads within the posts, all you have to do is sign up and they will go away!
  2. Welcome to Rc-Help, are you here looking for the PDF Plans? They are located in the store in the tab above, but you must be signed in to access that part of the site. It only takes a second to sign up!
  3. Like Us On Facebook!
    Hello Guest, it occurred to us during that last server failure that we had no way of informing the members of the site of the failure and I would like to invite you to like us on facebook so that you can get updates if the site happens to go down again. We don't post much over there unless we are updating the members so we will not flood your feed like some places do. Just click on Like and then allow notifications and that's it. See you there soon!

    Click Here To Rc-Help's Facebook page!
    Dismiss Notice
Dismiss Notice
Hey Guest, I see you are not signed up on our forum yet. Did you know Registration is FREE and is only a couple clicks away? You can even sign in from Facebook, Twitter or Google+ for your convenience! So what are you waiting for, CLICK HERE to join in on the conversation!

Misc. Soldering Iron, What Do You Use?

Discussion in 'Electronics' started by Tony, Nov 25, 2018.

< Xt-60h | Eflite 910mah Alternative >
  1. Tony

    Tony Administrator Staff Member

    Joined:
    Feb 21, 2011
    Messages:
    36,767
    Likes Received:
    1,423
    Trophy Points:
    113
    Yup, you are exactly right. I usually have mine set to 350C but as you stated, if I'm working on really small delicate parts, I turn it down, fat heat sink parts I crank that sucker to 11 (or about 500C lol). But I have only had to do that a few times, mainly on things like batteries where I need a fast joint to be made to keep heat from soaking into the project.
     
< Xt-60h | Eflite 910mah Alternative >

Share This Page