Onespeed
New Member
Doing a (nitro) gov configuration for first time. The setup. Ikon2BT running a Futaba BlS272 for Throttle on a Synergy 556. While centered in Ikon software (no changes made + or -) mounted arms parallel to each other while 50% throttle shown in software and 1/2 throttle mark shown on carb tumbler.
Question 1: After setting endpoints (no binding at full and no throttle) 50% in software does not line up with 1/2 throttle mark on carb anymore. Ignore this or problem ? ( I have changed the trim on the low throttle side to allow the 50/50 match, but I can no longer throttle cut engine in software as the endpoint is right at the idle area)
Question 2 What is default (no trim) for that servo in gov screen if i have to go back and look at geometry again.
Question 3 When all above is correct Verify the following is correct pls Throttle curve NM 0 25 40 40 40.... ID1 60 60 60 60 60... ID2 85 85 85 85 85 Hld ....good idle.... My hub has 2 magnets. pole is set to 1. 1 magnet is showing up in software. Im using an align sensor with beast x plug that i cut off and attached normal servo plug. Had to flip polarity to see in software. If i spin it fast its not catching it .....If i go slow it catches it. Thanks for your time!
Question 1: After setting endpoints (no binding at full and no throttle) 50% in software does not line up with 1/2 throttle mark on carb anymore. Ignore this or problem ? ( I have changed the trim on the low throttle side to allow the 50/50 match, but I can no longer throttle cut engine in software as the endpoint is right at the idle area)
Question 2 What is default (no trim) for that servo in gov screen if i have to go back and look at geometry again.
Question 3 When all above is correct Verify the following is correct pls Throttle curve NM 0 25 40 40 40.... ID1 60 60 60 60 60... ID2 85 85 85 85 85 Hld ....good idle.... My hub has 2 magnets. pole is set to 1. 1 magnet is showing up in software. Im using an align sensor with beast x plug that i cut off and attached normal servo plug. Had to flip polarity to see in software. If i spin it fast its not catching it .....If i go slow it catches it. Thanks for your time!