danhampson
Member
i had a slight altercation with the ground today practicing right side in hover, anyway i bent the mainshaft, feathering shaft, tail shaft, stripped the main gear and finally broke my brand new rail blades.
after going over the heli and replacing the bent/broken parts and giving the heli an all over inspection, i took her out to the garden to track the blades (blades had been already been balanced), she seemed to spool up out untill just over mid stick (throttle curve 0, 85, 85, 85, 85) (pitch curve -2, -1, 0, then linear) when she started jumping up and down. i took her to the bench and inspected the servos again, there is no notchyness when moving the manually but there is some play in one of them.
my cyclic servos are ds410m that came with my pro v2 3gx kit
after going over the heli and replacing the bent/broken parts and giving the heli an all over inspection, i took her out to the garden to track the blades (blades had been already been balanced), she seemed to spool up out untill just over mid stick (throttle curve 0, 85, 85, 85, 85) (pitch curve -2, -1, 0, then linear) when she started jumping up and down. i took her to the bench and inspected the servos again, there is no notchyness when moving the manually but there is some play in one of them.
my cyclic servos are ds410m that came with my pro v2 3gx kit
Last edited by a moderator: