buel williams
Active Member
calling all scale builders. just finished a 450 MD500 hovers fine but tail bounce's up and down any hints?
450 scale build
- Thread starter buel williams
- Start date
D.O.G.
Goblin 380 Supporter
A video will help out tremendously to see what's going on. My guess without a video is a bent tail shaft. My
buel williams
Active Member
I will take another look at that I saw no wobble in the shaft and it does't do it right off but when it's in the ir for a bit.A video will help out tremendously to see what's going on. My guess without a video is a bent tail shaft. My
D.O.G.
Goblin 380 Supporter
I use a cordless drill to check my main and tail shafts at high speed. It seems to work for me.
buel williams
Active Member
just thinking could it be torque tube bearing?
fran11784
Goblin 380 Supporter
It hovers fine and then the bounce comes on slowly? In my experience bearings or bent shafts will cause vibrations not bounces and wobbles. Not saying it's not possible though. I guess the other question besides what controller, is this a heli that flew fine before the fuselage or a new build?
T
T
buel williams
Active Member
yes it is a new build. I checked frame and set up before I installed it.