trainrider06
Active Member
Alright I have been muddling through this DX8 programming starting with my Blade SR....
I'm not sure about what switches I should program where....also the 3 position switch how I should set my pitch/throttle curves up, Gyro and what switch for that? Can I assign that to the F-mode switch and run that and dual rates also?
Also I discovered my throttle hold switch is not functioning properly! I have to flick it 2-3 times back and forth to get it to work....not good! May have to move that to the gear switch I think....hate that cuz I am already trained on the right switch for that and its on the same side as the Fmode switch....
I'm not sure about what switches I should program where....also the 3 position switch how I should set my pitch/throttle curves up, Gyro and what switch for that? Can I assign that to the F-mode switch and run that and dual rates also?
Also I discovered my throttle hold switch is not functioning properly! I have to flick it 2-3 times back and forth to get it to work....not good! May have to move that to the gear switch I think....hate that cuz I am already trained on the right switch for that and its on the same side as the Fmode switch....