Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
Featured content
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tony" data-source="post: 142518" data-attributes="member: 1"><p>Another thing you can try is to put a servo into the throttle port. I would do it with one that you don't care about since there is a possibility that it could hurt it, but it will at least tell you if a signal is getting though.</p></blockquote><p></p>
[QUOTE="Tony, post: 142518, member: 1"] Another thing you can try is to put a servo into the throttle port. I would do it with one that you don't care about since there is a possibility that it could hurt it, but it will at least tell you if a signal is getting though. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
Top
Bottom
