Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
Featured content
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tony" data-source="post: 142503" data-attributes="member: 1"><p>Try going into the travel menu and see if you can lower the low throttle point (raise the number for low throttle). I'm still thinking that it's not seeing a low throttle signal. </p><p></p><p>Have you made sure your throttle hold is not on? You can go into your monitor menu and see if the throttle channel is moving with the stick.</p></blockquote><p></p>
[QUOTE="Tony, post: 142503, member: 1"] Try going into the travel menu and see if you can lower the low throttle point (raise the number for low throttle). I'm still thinking that it's not seeing a low throttle signal. Have you made sure your throttle hold is not on? You can go into your monitor menu and see if the throttle channel is moving with the stick. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
Top
Bottom
