Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
Featured content
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tony" data-source="post: 142472" data-attributes="member: 1"><p>Try recalibrating your ESC. With everything off, turn on your Tx and raise the throttle all the way up (make sure the main and tail blades are off just in case). Plug in the helicopter and you should hear a set of tones. Once you hear the set of tones, lower the throttle all the way down. It should initialize the helicopter as usual. Let me know if this helps.</p></blockquote><p></p>
[QUOTE="Tony, post: 142472, member: 1"] Try recalibrating your ESC. With everything off, turn on your Tx and raise the throttle all the way up (make sure the main and tail blades are off just in case). Plug in the helicopter and you should hear a set of tones. Once you hear the set of tones, lower the throttle all the way down. It should initialize the helicopter as usual. Let me know if this helps. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
Top
Bottom
