Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
Featured content
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DMartin_nj" data-source="post: 142468" data-attributes="member: 6080"><p>Im new to helicopters. Had a cheap tx/rx in a 450, now have a good spektrum dx8g2. I want to use the new tx, installed an AR610 now I do not get any spoolup? </p><p></p><p>Is there some adjustment in the tx I am missing by chance? One would think it would still spoolup once everything is plugged into the new rx...</p><p></p><p>all I did was unplug wires from one rx to the new rx...</p></blockquote><p></p>
[QUOTE="DMartin_nj, post: 142468, member: 6080"] Im new to helicopters. Had a cheap tx/rx in a 450, now have a good spektrum dx8g2. I want to use the new tx, installed an AR610 now I do not get any spoolup? Is there some adjustment in the tx I am missing by chance? One would think it would still spoolup once everything is plugged into the new rx... all I did was unplug wires from one rx to the new rx... [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rc-Help Tech Section
Transmitters & Receivers
No spool up after replacing rx with AR610
Top
Bottom
