Flight Controllers New HK KK2 board

[Jerryz]

Hi everyone. I just installed my KK2 board on my Aerosky quad. When I power it up the screen shows "no yaw control input". I double checked my wiring. The connection for the rudder on the receiver, matches the connection on the rudder on the board. Any ideas?

 

[Stambo]

What TX and RX you using, might have more of an idea then.

 

[Jerryz]

What TX and RX you using, might have more of an idea then.

Yeah...I should have given just a tad more information. I am using the Spektrum OrangeRx receiver, and a Spectrum DX8 trans.

 

[Stambo]

First thing I would do is plug a servo in to the RX channel you are using to test that some thing is happening there.
That way we know whether the problem is lack of signal or KK2.
Have you been in to the KK2 and changed auto level to aux channel.

 

[Jerryz]

First thing I would do is plug a servo in to the RX channel you are using to test that some thing is happening there.
That way we know whether the problem is lack of signal or KK2.
Have you been in to the KK2 and changed auto level to aux channel.

Ok..I'll try that. No I have not made any changes to the board yet.

 

[Stambo]

First thing I would do is plug a servo in to the RX channel you are using to test that some thing is happening there.
That way we know whether the problem is lack of signal or KK2.
Have you been in to the KK2 and changed auto level to aux channel.

Oops ignore the last bit, I was watching 2 different threads about KK2