Hi I am new to rchelp & to Rc helis & trying to get my HK450 setup correctly.
I am using a Fly Sky T6 radio. I bought the heli off ebay & it was crashed, had to replace the blade holder. The problem I currently am having is getting the heli to hover. Also something is messed up & haven't been able to pinpoint it, the main rotor assem wobbles a little but the main shaft isn't bent & am not sure what causes that. Also after I get the heli in the air and hovering the heli is cocked on an angle as if I were banking to the left, I also noticed that I can see 2 lines from the main rotor as if 1 blade was lower than the other.
I would really appreciate any help, been trying to get this setup for a while now & have been through 3 sets of blades.
- - - Updated - - -
O, & I watched Tony's video on youtube "How to Completely Setup A CCPM Helicopter DX6i & OrangeRX"
I am using a Fly Sky T6 radio. I bought the heli off ebay & it was crashed, had to replace the blade holder. The problem I currently am having is getting the heli to hover. Also something is messed up & haven't been able to pinpoint it, the main rotor assem wobbles a little but the main shaft isn't bent & am not sure what causes that. Also after I get the heli in the air and hovering the heli is cocked on an angle as if I were banking to the left, I also noticed that I can see 2 lines from the main rotor as if 1 blade was lower than the other.
I would really appreciate any help, been trying to get this setup for a while now & have been through 3 sets of blades.
- - - Updated - - -
O, & I watched Tony's video on youtube "How to Completely Setup A CCPM Helicopter DX6i & OrangeRX"