James M. Lewis
Armed Forces
Hi everyone,
I've recently bought an ESC 40A Brushless Motor Speed Controller BEC 30A 6-12v thru ebay. The seller Cell expert (Chinese) had advertised the following information and with a good price, I figured it would fit my Gartt 450 Pro I'm building. The problem is it came without a manual/instructions sheet on how to program. I contacted the seller twice and they never did answer my question. All I got was a partial refund and they said they were sorry. Item is still in the package and never open. Now I'm at a lost because I don't know if this unit will automatically configure to my 450 or do I need some sort of program card/user manual. It came without connectors/pins, no problem I plan on using EC3 connectors. My other 450 has a Copter X ESC that came with a manual. Are ESC setup procedures universal that I could use my Copter X sheet ?
Here are the technical specs:
. High rate PWM ( don't know what that means but sounded good)
. Low resistance
. 16s max w/ BEC disable
. User programmable brake
. Low voltage auto setting based on battery
. Throttle range self adjusting
. Soft start ramp up
. Auto motor in forward/reverse
. Safe power arming program
. Low torque start
. Auto shut down when signal is lost
Any advice/input would be greatly appreciated. As always thanking you in advance.
Best regards,
Jim
I've recently bought an ESC 40A Brushless Motor Speed Controller BEC 30A 6-12v thru ebay. The seller Cell expert (Chinese) had advertised the following information and with a good price, I figured it would fit my Gartt 450 Pro I'm building. The problem is it came without a manual/instructions sheet on how to program. I contacted the seller twice and they never did answer my question. All I got was a partial refund and they said they were sorry. Item is still in the package and never open. Now I'm at a lost because I don't know if this unit will automatically configure to my 450 or do I need some sort of program card/user manual. It came without connectors/pins, no problem I plan on using EC3 connectors. My other 450 has a Copter X ESC that came with a manual. Are ESC setup procedures universal that I could use my Copter X sheet ?
Here are the technical specs:
. High rate PWM ( don't know what that means but sounded good)
. Low resistance
. 16s max w/ BEC disable
. User programmable brake
. Low voltage auto setting based on battery
. Throttle range self adjusting
. Soft start ramp up
. Auto motor in forward/reverse
. Safe power arming program
. Low torque start
. Auto shut down when signal is lost
Any advice/input would be greatly appreciated. As always thanking you in advance.
Best regards,
Jim