Hi to all. It's been a week sense I was here. At that time i was having issues with my servos an Rx. The Rx was putting out 3.4V on all CH Except CH4-5. They were at 1.3v. Not sure why. So today Hobby Partz sent me another one. (no cost) All checked out ok with new Rx. Needed to bind it . no problem. But I have no signal to any of the servos. Finally talked to tech at Hobby Partz. Got a rga to return Tx. I feel there is a set up problem of some sort. What I found is, In the Function setting.....Under Display I have no Real-time bar graft Display..Dosen't show any movement. Sure I can get a new Rx but mabe I can with ya'lls help fix it. Thanks... Duncan