Harford
Active Member
Another question please regarding a Trex 450L build. I am using a DX9 with the 450L & Microbeast Plus.
I have just acquired the DX9 so I have no experience with it (having used the original DX7 for the past few years).
I don’t know what I should be doing as far as programming the DX9 gyro function is concerned for this setup. I am using a single Spektrum satellite with the Microbeast.
The DX9 gyro menu option allows you to allocate a gain value to an independent switch (I could choose switch A). I assume I should do this, and if yes, what should the gains be initially please (I appreciate they may need to be fine tuned later).
The next question is what Channel do I assign this gyro function to please (eg Channel 5 , Gear ? – although CH5 on the Microbeast is used for the throttle/ESC)
It will be obvious I am a bit lost with this.
Many thanks
I have just acquired the DX9 so I have no experience with it (having used the original DX7 for the past few years).
I don’t know what I should be doing as far as programming the DX9 gyro function is concerned for this setup. I am using a single Spektrum satellite with the Microbeast.
The DX9 gyro menu option allows you to allocate a gain value to an independent switch (I could choose switch A). I assume I should do this, and if yes, what should the gains be initially please (I appreciate they may need to be fine tuned later).
The next question is what Channel do I assign this gyro function to please (eg Channel 5 , Gear ? – although CH5 on the Microbeast is used for the throttle/ESC)
It will be obvious I am a bit lost with this.
Many thanks