Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rc-Help Tech Section
Transmitters & Receivers
DX8 to DX9 model transfer
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bbj" data-source="post: 114351" data-attributes="member: 4117"><p>Finally got the DX9 setup with my Trex 500pro. The new transmitter seems to work even better than the old DX8 with regards to finer tuning of the servos or it could be just my imagination. I had to change some hard linkage also for the swash and a better 0 degree linkage change for the blades at 50in 50 out pitch. But now both blades are at 0 and almost the same degrees in both directions. I love this new DX9.</p></blockquote><p></p>
[QUOTE="bbj, post: 114351, member: 4117"] Finally got the DX9 setup with my Trex 500pro. The new transmitter seems to work even better than the old DX8 with regards to finer tuning of the servos or it could be just my imagination. I had to change some hard linkage also for the swash and a better 0 degree linkage change for the blades at 50in 50 out pitch. But now both blades are at 0 and almost the same degrees in both directions. I love this new DX9. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rc-Help Tech Section
Transmitters & Receivers
DX8 to DX9 model transfer
Top
Bottom
