Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
Featured content
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rc-Help Tech Section
Helicopters
Building the JR Vibe NEX E8 - Slow Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="coolgabsi" data-source="post: 29685" data-attributes="member: 22"><p>you'll have to excuse me Marius... man Its too early for me.. ( still) and I am bad at remembering terms and names on a good day.. well forget about that... would it not put stress on the servo? not just that going 25mm your overall pitch range will reduce.. If you already got like 14 or so.. then you'll end up being perfect. but still.. even if I am not right.. having non parallel push pull rods will have a significant change in the whole mechanics , servo torque and travel</p></blockquote><p></p>
[QUOTE="coolgabsi, post: 29685, member: 22"] you'll have to excuse me Marius... man Its too early for me.. ( still) and I am bad at remembering terms and names on a good day.. well forget about that... would it not put stress on the servo? not just that going 25mm your overall pitch range will reduce.. If you already got like 14 or so.. then you'll end up being perfect. but still.. even if I am not right.. having non parallel push pull rods will have a significant change in the whole mechanics , servo torque and travel [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rc-Help Tech Section
Helicopters
Building the JR Vibe NEX E8 - Slow Build
Top
Bottom
