I joined this site, when I bought the Blade 450 3d, which I set up, per video. I then crashed and had to replace the main drive gear. I went through the set up again. I crashed again, this time I took out the tail boom and tail rotor housing. I replaced all of the damaged parts the I could see.
Now the belt tracks to the port side of the tail boom and comes off the pulley. I will not reassembled any more, until I find out how to center the belt on the pulley and keep it there. I am worried about wearing out the screw holes in the plastic, from multiple R&Rs.
Any help would be welcomed.
Bob
Now the belt tracks to the port side of the tail boom and comes off the pulley. I will not reassembled any more, until I find out how to center the belt on the pulley and keep it there. I am worried about wearing out the screw holes in the plastic, from multiple R&Rs.
Any help would be welcomed.
Bob