Icehunter
New Member
I am trying to corner the market on used AR7200BX units. Well maybe not but just picked up 5 of them. Can a person hook up a separate battery pack to them,run it thru a switch and bind without using the esc? I am just going to use a 4.8 V RX spectrum pack with switch. Then at the same time,get it into program mode and do a reset on it. Then I can mount them in the heli"s that I am converting over,or building from new.
Like say my 500 t-rex with new esc. If I was to pre bind and reset on the bench then all I have to do is set up the esc with it. All the setup vids I have watched always hook the 7200 up to a esc. It might sound like extra steps,but I have never used a 7200 before and wanted to check.
Like say my 500 t-rex with new esc. If I was to pre bind and reset on the bench then all I have to do is set up the esc with it. All the setup vids I have watched always hook the 7200 up to a esc. It might sound like extra steps,but I have never used a 7200 before and wanted to check.