Hi all
I've set up using the video's here which have been great, but I have a problem.
With everything powered up but no input from the radio, the tail rotor slowly moves from central to being against the boom.
If I manually spin the heli from left to right the tail rotors move in the correct manner, but just sat on the skids it creeps back to
the linkage being against the boom again! It takes about a minute to go from middle to against the boom.
I've set the DX9 up as per instructions so I'm not sure where I've gone wrong?
All the servos sing a little after the 3GX has initialized, I'n guessing that is because it is on the floor...
The DX9 is v7 and the 3GX is v5. I'm v43 learner (",)
Thanks in advance for any help
Steve
I've set up using the video's here which have been great, but I have a problem.
With everything powered up but no input from the radio, the tail rotor slowly moves from central to being against the boom.
If I manually spin the heli from left to right the tail rotors move in the correct manner, but just sat on the skids it creeps back to
the linkage being against the boom again! It takes about a minute to go from middle to against the boom.
I've set the DX9 up as per instructions so I'm not sure where I've gone wrong?
All the servos sing a little after the 3GX has initialized, I'n guessing that is because it is on the floor...
The DX9 is v7 and the 3GX is v5. I'm v43 learner (",)
Thanks in advance for any help
Steve