Clifford Poddar
New Member
I wanted to ask anyone if this was a common occurrence, or point me to a possible reason why I burnt out 2 of my servos while setting up the 3gx on my Trex 450. I haven't played with any of my helicopters in some time, and decided to set one up again to fly. I have Hitec HS-5065MG for the ccpm. My 3gx was on version 2, and I updated it to v5. All the servos were working great for the past few days while working on the helicopter. But when I decided to setup the 3GX two of them burnt out. I was in the dir menu when it happened.
I should mention that I've had these servos for some time and they've been working great even before I went flybarless about 1-2 years ago, so i know they were working great. They were also working great for the past few days before I upgraded to v5, when I took the helicopter out to see if it was still calibrate correctly. I only hovered the heli.
I did plug in the 3gx to my computer to ensure it the settings were on digital and 1520, and it was fine.
Any ideas? Thanks for your time and help!
I should mention that I've had these servos for some time and they've been working great even before I went flybarless about 1-2 years ago, so i know they were working great. They were also working great for the past few days before I upgraded to v5, when I took the helicopter out to see if it was still calibrate correctly. I only hovered the heli.
I did plug in the 3gx to my computer to ensure it the settings were on digital and 1520, and it was fine.
Any ideas? Thanks for your time and help!