Peter Vice
Member
Good morning Tony,
After hovering and fighting my heli just to do steady left and right flying I decided to go back to basics and check a few manual settings.
I took out all trims and did the mechanical set up for the swash plate all went well the swash plate seemed to move up and down fairly level but as soon as I exit the program it cocks backward and the rear of the swash plate is no longer level, When I slide the stick up and down the gap progressively increases, this has always been a problem and when I fly I have to constantly hold my stick forward and slightly to the right, any suggestions? I have 90 my servos as best as possible. Regards, Peter
After hovering and fighting my heli just to do steady left and right flying I decided to go back to basics and check a few manual settings.
I took out all trims and did the mechanical set up for the swash plate all went well the swash plate seemed to move up and down fairly level but as soon as I exit the program it cocks backward and the rear of the swash plate is no longer level, When I slide the stick up and down the gap progressively increases, this has always been a problem and when I fly I have to constantly hold my stick forward and slightly to the right, any suggestions? I have 90 my servos as best as possible. Regards, Peter