Quad Turnigy 9x Help!

[Declan]

Hi, struggling to get aileron to go centre it only works 50%+ wont go down to 0% it seems to be tied into the throttle channel?

Also failsafe, how is It set so you turn the handset off & dji naza m lite goes into go home mode?

 

[Tony]

It sounds like you have some mixing in the Tx. Not sure what you are working on model wise, but usually there should be no mixing. Have you tried creating a new model and starting over?

 

[Declan]

yes it doesn't make a difference

 

[Declan]

This is my problem, stick back all the way only reads 366 when it should read a full value like 966+ like it shows when full forward.. end points are all the same? what is wrong please help

 

[Smoggie]

Have you by any chance set the transmitter in helicopter mode with CCPM mixing?

That's all I can guess, Open Tx firmware like used in the 9X can be baffling and very complex so you probably need an Open Tx guru to advise

 

[Stambo]

Stock 9x is not OpenTX Tony.

Declan, are you using stock 9x firmware or has it been flashed to OpenTX?
I'll have to grab my sons 9x and do myself a quick refresher course.
I never had any problems getting it to work on a multirotor when it was my only TX.

 

[Tony]

Um, I never said it was. All I said was it sounded like there was some mixing in it and to try a new model...

 

[Stambo]

Um, I never said it was. All I said was it sounded like there was some mixing in it and to try a new model...

Sorry Tony was half asleep replying to this, was aimed at Smoggie

Have you got this sorted yet Declan?

 

[Tony]

lol, I do my worst writing when I'm half asleep hahaha.