Flight Controllers I Need Helpppp

Cirilo Escandon

New Member
I have a naze 32 rev6 with cleanflight on it. It is able to connect and everything but when I go to transmitter and turn on my transmitter it shows no signs that a transmitter is connected I even rebinded my Rx and TX but it's still not working can anyone help?
 

Tony

Staff member
Make sure in the ports tab that you have the correct UART turned on for your Rx and that under the Configuration tab that you have the correct Rx listed.
 

Admiral

Well-Known Member
If the Cleanflight can see the Naze unit & the Tx is bound to the Rx OK it must be the connection between the Rx and the unit.
How are they connected PPM (1 Wire) , PWM (Several wires) , SBUS or MSP ?
Check on the Configuration page under Receiver that the correct protocol is selected.
 

Cirilo Escandon

New Member
If the Cleanflight can see the Naze unit & the Tx is bound to the Rx OK it must be the connection between the Rx and the unit.
How are they connected PPM (1 Wire) , PWM (Several wires) , SBUS or MSP ?
Check on the Configuration page under Receiver that the correct protocol is selected.
It's connected by pwm
 

Admiral

Well-Known Member
Pining is normally

1 = Aileron
2 = Elevator
3 = Throttle
4 = Rudder
5 = Aux #1
6 = Aux #2
7 = Aux #3
7 = Aux #4

But check the manual for your board.
 
Top Bottom