tommyboy660
Member
Wow. So i have owned an Align Trex 450 pro 3GX since the end of May & have bought everything imaginable for it as far as any upgrades or add ons not installed anything yet and i havent flown it at all even once because i havent taken the time to sit down and configure the stupid thing as far as the gyro unit so i went ahead and bought me a Blade 450 3D because i own a DX7S and it was a bind and fly heli so i figured i wouldn't have to get frustrated trying to set it up or anything. Today after finally switching out the battery connectors last night to work with my batteries i flew the heli for the first time. Given i didnt get it off the ground more than about 2 feet because i have not only not flown it but i have never flown any heli. So i just downloaded the files from Horizons site for my TX and it was that easy. But anyway i only flew for about 3 minutes on and off and then i decided to push the throttle a little bit just to get it off the ground then i noticed it was flying towards a ladder so i quickly let off the throttle completely and it was alittle to late and the blades hit the ladder and broke but nothing else luckily broke so i actually feel pretty good about this cuz atleast i finally flew one of the heli's. No i didnt get any video sorry it wasnt even long enough.
So now i have to replace the stock wooden blades then try it out again, but while i was trying it out i noticed it always was pulling towards the left even after i was adjusting the trim tabs so i need to figure that out aswell. Thanks tom
So now i have to replace the stock wooden blades then try it out again, but while i was trying it out i noticed it always was pulling towards the left even after i was adjusting the trim tabs so i need to figure that out aswell. Thanks tom