Santiagonqn
New Member
Hello,
this is my first post. I am having troubles configuring my turnigy 85A esc.
the issue is as follows.
1st test. 100% throttle. enters programming mode. everything seems fine.
2nd test. 100% throttle within first 2 sec, throotle to minimum. This is to set the "throttle range".
3rd test 0% throttle. when I go to 100% and it suddenly cut off.
I have already configured "low voltage cut off type" from "reduce power" to "hard cut off".
I am running a 3s lipo with 12,3v, not low at all, and it keeps cut of a feew seconds after start up.
Please refer to this 2 min video to better understanding. I made it myself
http://youtu.be/M4LnFDKm1oQ
Thank you so much in advance. Hope someone could help me.
Regards,
Santiago
this is my first post. I am having troubles configuring my turnigy 85A esc.
the issue is as follows.
1st test. 100% throttle. enters programming mode. everything seems fine.
2nd test. 100% throttle within first 2 sec, throotle to minimum. This is to set the "throttle range".
3rd test 0% throttle. when I go to 100% and it suddenly cut off.
I have already configured "low voltage cut off type" from "reduce power" to "hard cut off".
I am running a 3s lipo with 12,3v, not low at all, and it keeps cut of a feew seconds after start up.
Please refer to this 2 min video to better understanding. I made it myself
http://youtu.be/M4LnFDKm1oQ
Thank you so much in advance. Hope someone could help me.
Regards,
Santiago