Doum066
Member
Greetings all,
I'm new here, and as i can say still new in this hobby.
I got my self my new and first build last week, not easy to start building this up, thanksfully i found Tony's videos building a Pro V2 3GX, really helpful.
Here's my problem, as i followed is videos, last night, i took off all my servos, centered set them up, them reposition them in the frame, now, tonight as i almost fnished this first build, after wiring stuff up, i turn on the TX, then plug in the battery, then i start to hear a non-stop buzzing from my Spektrum's AR7200BX.. woundered what my prob was, so is tarted to trouble shoot, pluged only on servo at a time to see which one is causin this, and ended up being my Rudder... then with lots of tries to troubleshhoot, i realised it does that when i plug to the servo, the Rudder link Rod, as if it's trying hard to move, so i tried lots of stuff, one ball link in on one side, no prob.. etc.. i tried to loosen up the balll link on both ends of the rod, and even screw them back again... no success,,,
Any cluw how i could properly set my tail?
Thanks
I'm new here, and as i can say still new in this hobby.
I got my self my new and first build last week, not easy to start building this up, thanksfully i found Tony's videos building a Pro V2 3GX, really helpful.
Here's my problem, as i followed is videos, last night, i took off all my servos, centered set them up, them reposition them in the frame, now, tonight as i almost fnished this first build, after wiring stuff up, i turn on the TX, then plug in the battery, then i start to hear a non-stop buzzing from my Spektrum's AR7200BX.. woundered what my prob was, so is tarted to trouble shoot, pluged only on servo at a time to see which one is causin this, and ended up being my Rudder... then with lots of tries to troubleshhoot, i realised it does that when i plug to the servo, the Rudder link Rod, as if it's trying hard to move, so i tried lots of stuff, one ball link in on one side, no prob.. etc.. i tried to loosen up the balll link on both ends of the rod, and even screw them back again... no success,,,
Any cluw how i could properly set my tail?
Thanks