Just used the Blade swashplate leveling tool on my Blade 450 3D using the instructions from the web site. Curious as to if there's a value when using the sub-trim (DX6i) to level the servo arms that it is better to loosen and reposition the arm?
I was surprised at the amount I had to adjust sub-trim and lengthen the link for the elev.. The other servos only needed a bit of sub-trim to level the arms.
I was surprised at the amount I had to adjust sub-trim and lengthen the link for the elev.. The other servos only needed a bit of sub-trim to level the arms.