RadioM204213
New Member
I have the spectrum I asked 20 and I'm having an issue or hit something wrong.
If you look at the monitor and you move the throttle stick the monitor does not move until the throttle stick is at quarter throttle. I was told her she had nothing to do with endpoints sub trim or anything at this point.
I'm not sure what was going on but they seem to be fine before and again I plug a different receiver in different servo a completely different set up and it's the same thing the throttle does not move the monitor until quarter throttle.
Any real ideas would be very helpful thank you. I was going to put something on YouTube because obviously attaching a file is too big but hopefully somebody will have an answer for me thank you.
Bob USA
If you look at the monitor and you move the throttle stick the monitor does not move until the throttle stick is at quarter throttle. I was told her she had nothing to do with endpoints sub trim or anything at this point.
I'm not sure what was going on but they seem to be fine before and again I plug a different receiver in different servo a completely different set up and it's the same thing the throttle does not move the monitor until quarter throttle.
Any real ideas would be very helpful thank you. I was going to put something on YouTube because obviously attaching a file is too big but hopefully somebody will have an answer for me thank you.
Bob USA