trainrider06
Active Member
Ok i have set this gyro up with a DX6i about a year ago, on a 450 heli, got a DX8, bound it to the 8, and now for some reason I cannot get this thing in program mode for tail setup.
I did get it into setup for the tail servo, but after that I am stuck....
When i initialize the heli flick the gyro switch back and forth now, it will twitch the servo, but will not seem to go into setup (light stays solid) I remember it was a little bit of a pain before but not too bad.
Anyone know what I might be missing here?
I did get it into setup for the tail servo, but after that I am stuck....
When i initialize the heli flick the gyro switch back and forth now, it will twitch the servo, but will not seem to go into setup (light stays solid) I remember it was a little bit of a pain before but not too bad.
Anyone know what I might be missing here?