I finished assembling my Trex 450 Sport V2 (tail belt driven). I had a bit of vibration when spooling up for blade tracking adjustment and after checking noted excessive play up and down with the main shaft. I installed spacers totalling 1mm (5 @ 0.2mm) before the shaft was solid. Is this an acceptable amount of spacers or is something out of spec.? I did have the shorter end of the main shaft into the gears.
Also, compared to my Blade 450 the swash movement doesn't appear to have as great a range, I used the +60% swash mix numbers recommended in Tony's video for the DX6i setup. Would increasing the swash mix settings increase the range of movement for the swash?
Also, compared to my Blade 450 the swash movement doesn't appear to have as great a range, I used the +60% swash mix numbers recommended in Tony's video for the DX6i setup. Would increasing the swash mix settings increase the range of movement for the swash?