RCH Edge 540

[bsuvansh]

just completed RCH Edge 540 in 2hrs
i have not used the kmf4 airfoil in the wing and for more support i have used carbon rod as it was in the plans
installed landing gear with the steering rudder too!!!!

 

[Tony]

Is that made out of 9mm depron? Can't wait to see it in the air.

 

[bsuvansh]

no it's made out of 8mm depron or u can say 8mm styrofoam
yup ill be going today at evening

 

[Derek]

The 540 looks good buddy! Good luck with the maiden flight!!!

 

[bsuvansh]

thanks
can any one tell about the cg point on this plane

 

[rchelipilot]

Nice, hope it flies great.

 

[idon'tknow!]

looks good! I think it says on the plans, but I could be wrong.

 

[bsuvansh]

its a nice plane
great characteristics
nice for aerobatics

 

[Tony]

IDK, the plans are not finished yet and they do not have the CoG marked on them. I have not had a chance or the time to build this plane so I have no idea where to put it as of yet. I'm hoping things slow down here soon so that I can get it out and fly it.

 

[idon'tknow!]

IDK, the plans are not finished yet and they do not have the CoG marked on them. I have not had a chance or the time to build this plane so I have no idea where to put it as of yet. I'm hoping things slow down here soon so that I can get it out and fly it.

whoops, I must have confused plans...sorry. bsuvansh, you can test the CG by giving it a test glide (while your running under it) and if it glides good, CG is good, if it goes noes up it tail heavy, if it dives, than yes it's nose heavy, hope this helps, just be careful when doing this to only throw the plane as fast as you can run.

 

[canongraphy]

looks like your ready

 

[bsuvansh]

thanks idon'tknow!