SP1D3R
New Member
New to the hobby. I'm currently in the set up phase of my Oxy 2 build. As I go through the Micro Brain 2 / Ikon software wizard - I'm having some issues at the servo set up menu. It seems as though when I enter check mode, I'm able to level my swash plate and all my flight controls work perfectly - all servos return to their neutral position immediately. However, the moment that I leave check mode, the servos change position and no longer have the same crisp return to neutral, or don't return to neutral at all. I can't figure out why everything works perfectly in 'check mode' (both in wizard, and check box in advanced) - but the moment check mode is deactivated the servos lose their zero.
If I close the software and disconnect the FBL from my PC, check mode stays on and the flight controls remain crisp, but once power is cycled to the unit, the servos reset again. Can anyone help me understand why my flight controls only respond properly in 'check mode?'
If I close the software and disconnect the FBL from my PC, check mode stays on and the flight controls remain crisp, but once power is cycled to the unit, the servos reset again. Can anyone help me understand why my flight controls only respond properly in 'check mode?'